ProMinent DULCOLEVEL Manual De Instrucciones Originales página 13

Initial Startup
The sensor is connected to the pump and the pump is
displayed in the "Devices" view in the "Connected" tab.
Note: During set-up you will need the last 4 digits of your
sensor's and pump's serial numbers.
Alternative: Connect Sensor Only
If you do not have a pump with Bluetooth
use the sensor with a PLC as described in application
option 3, follow the steps below.
Prerequisites:
DULCONNEX Blue App is installed on your mobile
„
device. You cannot set up or operate the sensor
without the app.
Bluetooth is enabled on your mobile device.
„ ®
The sensor is connected to power.
„
Procedure:
1. Open DULCONNEX Blue on your mobile device.
2. Switch to the "Devices" view.
3. Tap on
All Bluetooth devices that are nearby are displayed.
4. Tap on + next to the sensor's name.
The sensor will be connected to the app. If the con-
and want to nection is successful, a message appears.
®
5. Enter device PIN.
Note: The PIN is the last 4 digits of the sensor's serial
number.
The sensor is connected to the app and is displayed in
the "Devices" view in the "Connected" tab.
+
.
13 EN