Publicidad
Idiomas disponibles
Idiomas disponibles
9. Place the worktop on the appliance with the door closed. Check, that the top axis meets the
top opening (where the seal plug was). Fasten the 2 top screws first and then the screws on
the back slightly. Adjust the worktop properly. Check, that the door is adjusted perpendicularly.
10. Now tighten all 4 screws of the worktop. Do not tighten the screws too firmly.
Fig. 1
Remove the worktop by removing the 2 screws on the top and the
two screws on the back.
Remove the 2 cover caps on the top with a small flathead screwdriver
before.
Fig. 2
Remove the hinge and fix it on the opposite side.
Do not tighten the screws too firmly.
Fig. 3
36
Publicidad
