5. Empty the waste material container and use a water hose to rinse it out. Use a brush to clean the
electrodes and clean the filter element, after allowing it to dry, by wiping it off with your hand.
6. Allow the waste material container to dry.
6.10
After use of the vacuum cleaner
1. Switch off the electric tool.
2. Turn the vacuum cleaner control switch to the "OFF" position.
3. Unplug the vacuum cleaner's supply cord from the power outlet and remove installed batteries.
4. Coil up the supply cord and hang it on the hook.
5. Empty the container and clean the appliance by wiping it with a damp cloth.
6. Coil up the suction hose.
7. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized users.
6.11
Removing the battery
1. If applicable, remove all items (e.g. Hilti toolbox(es)) attached by the adapter plate to the suction head.
2. Open the battery compartment cover.
3. Press both battery release buttons simultaneously and pull the battery out of the tool.
6.12
Emptying the waste material container
▶ Before emptying the material vacuumed up, remove all items (e.g. Hilti toolbox(es)) attached by the
adapter plate to the suction head.
6.12.1 Emptying dry dust from the waste material container
1. Unplug the vacuum cleaner's supply cord from the power outlet and remove installed batteries.
2. Lift the suction head off the waste material container and place it on a level surface.
3. If the following equipment exists, also take this action:
VC 20-UM-Y
VC 40-UM-Y
▶ Remove the dust bag from the waste material container.
4. If the following equipment exists, also take this action:
VC 20-U-Y
VC 40-U-Y
▶ Remove the dust bag from the waste material container or grip the container by the recess provided
and empty it by tipping out the contents.
5. Fit the suction head on to the waste material container and close the two catches.
6.12.2 Emptying the waste material container when no dust bag is fitted (vacuuming up liquids)
1. Unplug the vacuum cleaner's supply cord from the power outlet and remove installed batteries.
2. Lift the suction head off the waste material container and place it on a level surface.
3. Hold the waste material container by the grip recesses provided and empty it by tipping out the contents.
4. Clean the edge of the waste material container with a cloth.
5. Fit the suction head on to the waste material container and close the two catches.
6.13
Operation as charging station
Overview of the status indicator of the charging station:
Status
LED lights constantly
Flashing light
32
English
3
Meaning
The appliance is connected to the AC supply and is
ready to function.
The battery is too hot or too cold; charging does
not take place. The charging station switches auto-
matically to charging mode as soon as the battery
reaches the required temperature.
2055199
*2055199*