Hilti VC 20-U-Y Manual De Instrucciones página 27

1.2.3 Symbols in the illustrations
The following symbols are used our in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section
This symbol is intended to draw special attention to certain points when handling the product.
Wireless data transfer
1.2.4 Additional symbols
The following symbols are used on the product:
Transport by crane is not permissible
1.3 On the device
VC 20-UM-Y
VC 40-UM-Y
WARNING: This device contains hazardous dust. Only informed persons wearing suitable protective
equipment are permitted to undertake emptying and maintenance, including removal of the dust bag.
Do not switch on until the complete filter system has been installed and operation of the volume-flow
monitor has been tested.
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Wet / dry vacuum cleaner
Generation
Serial no.
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
*2055199*
2055199
VC 20-U-Y | VC 20-UM-Y |
VC 40-U-Y | VC 40-UM-Y
01
English 21