Publicidad
Idiomas disponibles
Idiomas disponibles
3.2"
MACHINE PLACEMENT
Place turntable at desired location. Ensure there is
sufficient room to load/unload the machine. Wire and
that you do not stretch the wiring cable.
NOTE: Turntable is powered by a 120 VAC,
15-AMP outlet.
FLOOR WEIGHT BEARING TOLERANCE
IMPORTANT! Floor must be able to support the
weight of the machine, maximum load and
stress of operation.
IMPORTANT! If fork trucks will operate on the
same weight bearing area of floor, add the
weight of the trucks to the weight bearing
stress tolerance requirements.
PAGE 2 OF 15
SPECIFICATIONS CONTINUED
100.4"
SET-UP
Turntable
Speed Pot
ø65"
MACHINE SET-UP
Place skidded machine close to the designated
wrap area. Remove all shipping fasteners holding
the machine to the pallet. Place forks of the forklift
through the tubes provided at the rear base of the
module, remove the machine from these skids, and
place it at the designated wrap area.
H-2958 RAMP (OPTIONAL)
Select a ramp position. The ramp can be positioned
anywhere in a 180° rotation around the front of the
turntable. There should be a 1/4" gap between the
turntable and the ramp. The ramp should be fully
supported by the floor. Both the ramp and the machine
should be lagged to the floor when ramp is used.
0223 IH-1287
Publicidad
