Publicidad
Idiomas disponibles
Idiomas disponibles
POWER AND CONTROL WIRING CHECKS
1. Using a voltage meter, check the AC voltage
coming to the system to insure proper voltage
is present.
1. Step on the foot pedal to start the turntable drive
motor. The foot pedal is a maintained switch.
Pressing the pedal again turns the turntable motor off.
WARNING! All maintenance operations require
the equipment to be powered down and
locked out for personnel safety.
LOCK-OUT/ TAG-OUT PROCEDURES
Be sure that anyone performing any type of
maintenance on this equipment is familiar with and is
adhering to the lock-out/tag-out procedures set forth by
the General OSHA or the State OSHA guidelines.
VISUAL CHECKS
Visual checks should be conducted at least once per month:
1. Keep the machine and surrounding area as clean
as possible, especially near moving components.
2. Check for loose hardware, especially set screws
located in: sprocket hubs, bearing hubs, and flanges.
3. Check for loose cotter pins.
4. Check for dry seals at the bearings.
5. Check for loose electrical connections and for
frayed cords and cables. Replace immediately
any damaged cords and cables.
PAGE 3 OF 15
SET-UP CONTINUED
2. Plug the power cord into a 120VAC outlet. Power
should be applied to the frequency drive and foot
switch.
OPERATION
TURNTABLE SPEED ADJUSTMENT
Turntable speed is adjusted by a built-in potentiometer
dial on the electrical enclosure. Turn clockwise to
increase, and counter-clockwise to decrease speed.
Maximum turntable speed is 12 rotations-per-minute
(RPM).
MAINTENANCE
TURNTABLE BEARING LUBRICATION TAB
If the turntable becomes noisy during operation, the
supporting cam follower bearings under the turntable
top may need replacement. The bearings are sealed
and lubed for life, but will require replacement after
several years of regular use. It is necessary to replace
the entire cam follower assembly (bearings and plastic
housing), not just the bearings, should the bearings
become worn.
The King Post Assembly (center bearing) is also
replaced as a unit rather than individual components
when worn.
WARNING! Failure to follow maintenance
procedures will reduce the life of your
turntable and manufacturer's warranty
obligation.
0223 IH-1287
Publicidad
