Publicidad
Idiomas disponibles
Idiomas disponibles
TURNTABLE BELT ADJUSTMENTS
Loosen the four reducer plate bolts. Adjust the position
of the reducer to the desired belt tension using the rear
tensioning bolt. Retighten the four reducer plate bolts.
MISCELLANEOUS PIVOT AND ROTATING BEARINGS
All bearings not previously mentioned should be
greased bi-monthly using Mobile EP-1 or equivalent.
WARNING! Only qualified personnel should
perform inspection, troubleshooting and part
replacement.
OPERATING ISSUE
Machine not powering on.
PAGE 4 OF 15
MAINTENANCE CONTINUED
TROUBLESHOOTING
CAUSES
The system is not plugged into a 120 VAC outlet.
Doesn't have continuity.
The frequency drive circuit breaker is not on.
It is not receiving the charge.
It is not receiving 120 VAC.
MAINTENANCE SCHEDULE TABLE
PART
Turntable Belt Drive Tension
(For Predator Low Profile Only)
Gear Motor
NOTE: Refer to Electrical and Mechanical
component's Operations Manuals shipped
inside the enclosure for additional
maintenance information.
CAUTION! Disconnect all power including
external control power that may be present
before servicing the frequency drive
controllers. WAIT three (3) minutes for the DC
bus capacitors to discharge. The frequency
drive controller' display and/or LED's are not
accurate indicators of the absence of DC bus
voltage.
RECOMMENDATIONS
Plug machine into a 120 VAC outlet.
Use a voltmeter to test continuity of the power cord.
Replace the power cord to the machine.
Replace the main circuit breaker.
Switch the main circuit breaker on.
Use a voltmeter to read input voltage to the frequency
drive. Tighten or replace wiring to the frequency drive(s).
Use a voltmeter to read input voltage to the frequency
drive.
Tighten or replace wiring to the frequency drive(s).
Replace the frequency drive(s).
SCHEDULE
Check and adjust every three
months.
The gear motor is filled with oil
and sealed, no maintenance is
required.
0223 IH-1287
Publicidad
