Enerpac SQD Serie Manual De Instalación página 10

6.0 MAINTENANCE AND SERVICE
IMPORTANT: To safeguard the
accuracy of the torque values,
the torque wrench and pressure
gauge on the pump must be
checked on a regular basis.
Contact Enerpac for calibration.
Repairs must be made by the manufacturer,
as after an exchange of parts, the accuracy
of the torque and the wrench functions must
be checked. Maintenance is required when
wear and/or leakage is noticed. Regularly
inspect all components to detect any
problem requiring service and maintenance.
Contact your Enerpac representative for
repair and/or replacements.
To prolong the life of your torque wrench
equipment, follow the points below:
• Do not exceed oil temperature of 65˚C
(150˚F).
• Regularly check the pumps' oil level and
condition. Consult pump instructions.
14
• Follow the
paragraph 6.1.
• Lubrication
accuracy and life-time of the wrench.
Always clean and lubricate after usage
and store in the carrying case.
6.1 Lubrication
Follow the scheme below. The icons
refer to parts or surfaces of the wrench in
14
illustration .
• Clean surface
Gleitmo 805 only. Available at Enerpac as
Torque Wrench Grease EN-14010.
• Keep surface
lubricate.
IMPORTANT: Do not disassemble the
wrench unit (1) or the drive release (5). Do not
immerse these parts in oil, kerosene or other
cleaning liquid to prevent dirt from flushing in
and grease from being dissolved.
10
lubrication scheme
may influence
and grease with
clean and dry. Do not
in
torque
and