Enerpac SQD Serie Manual De Instalación página 6

8
WARNING: See
personal injury, do not remove the protection
plate or modify the wrench, its accessories
or change the safety valve setting on the
swivel hose connection.
4.0 ASSEMBLING THE WRENCH
9
See . All parts must be free of dirt and
greased according paragraph 6.1 Follow the
steps below:
A
Slide the reaction arm (6) over the
wrench body (1) in the correct position.
3
See also and
arm with the locking mechanism (3).
B
Push drive release (5) into the wrench (1)
and position the square drive (4).
C
Push the button in the drive release (5)
and push square drive (4) against (5).
D
Keep pushing (4) while pressing and
turning (5) so both parts click into the
locked position. Check this by pulling
the square drive.
E
Secure the socket (7) on square drive (4)
using a locking pin (8) and O-ring (9).
IMPORTANT: The Allen-key drive fits in
the same way in the drive release as the
square drive (4). When using the Allen-
key drive the reaction arm for Allen-key
drives (8) must be used.
F
Connect the Enerpac THC-700 series
3,5:1 safety twin hoses (10) to the swivel
hose connection (2).
WARNING: See
correct way to connect the hoses
between wrench and pump.
8
. To avoid damage and
5
. Secure the reaction
10
on page 7 for the
9
A
B
C
D
E
F
6