EAS ELECTRIC EMW580E2 Manual De Usuario página 37

ADJUST LEG
1.
When positioning the washing machine, please first check
if the legs are closely attached to the cabinet. If not, please
turn them to their original positions with hand or spanner
and tighten the nuts with spanner.
2.
After positioning the washing machine, press four corners
on top cover of washing machine in sequence. If the
washing machine is not stable when being pressed, this
leg shall be adjusted.
3.
Ensure the positioning status of washing machine. Loosen the lock nut
with spanner and turn the leg with hand until it closely contacts with the
floor. Press the leg with one hand and fasten the nut closely to the cabinet
with the other hand.
4.
After being locked properly, press four corners again to make sure that
they have been adjusted properly. If it is still unstable, it must repeat Steps
2 and 3.
5.
Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the
washing machine from in the left, right, front and back directions. If the
cylinder keeps stable, the washing machine is positioned level. If it rolls,
the washing machine is positioned unlevel. The rolling direction is the
direction of lower ground surface. Then, the two legs in this direction shall
be raised at the same time until the washing machine is level. Steps 1~3
are repeated to make the bottom legs closely against the ground and the
nuts shall be locked tightly.
CONNECT INLET PIPE
Connect the inlet pipe as indicated in the figure.
For the model, which has hot valve, please
connect the hot vale to hot water tap. Energy will
decrease automatically for some program.
INTALL INLET PIPE
1. Connect the elbow to tap and fasten
it clockwise.
2. Connect the other end of inlet pipe to
the inlet valve at the backside of
washing machine and fasten the pipe
tightly clockwise.
V. 1
37