Introduction
List of pictograms used
Please read the operating instructions!
Safety class II
Observe warnings and safety
notices!
Warning! Risk of electric shock!
This light is not suitable for dimmer or
electronic switches.
LED Floor Lamp
Introduction
Congratulations on the purchase of your
new appliance. You have selected a
high quality product. Please be sure to
carefully read all the instructions for use. Fold out
the page with the illustrations. These instructions
are part of the product and contain important infor-
mation on setup and handling. Always follow all
safety instructions. Before using this product for the
first time verify the correct voltage and that all parts
are properly installed. If you have any questions or
you are unsure about operating the product, please
contact the distributor or service centre. Please keep
these instructions in a safe place and pass them on
to third parties if necessary.
Intended use
This light is only suitable for indoor use
in dry and enclosed spaces.
This product is intended for private household use only.
12 GB/IE
This light is only suitable for indoor
use in dry and enclosed spaces.
For your safety
Warning - hot surfaces!
Dispose of packaging and
appliance in an environmentally-
friendly manner!
b
a
Scope of delivery
Check immediately after unpacking that the parts
are complete and that the product is in proper
condition.
1 LED Floor Lamp (14123406L or 14123405L)
1 LED Lamp, E27, 7 W
1 Support tube (divided into three parts)
1 Base
1 Lamp shade
1 Set of assembly instructions and instructions for use
Parts Description
Illuminant
1
Lamp ring
2
Lamp shade
3
Socket
4
Upper support tube
5
Middle support tube
6
Lower support tube
7
ON / OFF foot switch
8
Mains plug
9
Base
10