Publicidad
Idiomas disponibles
Idiomas disponibles
Initial use / Changing the bulb / Maintenance and cleaning / Disposal
Initial use
Mounting the light
Note: During installation, please ensure that you
slowly pull the cable through support tubes or through
the opening of the lower support tubes
Insert the upper support tube
support tube
and screw it in tightly. Then in-
6
sert the screwed together support tube into the
lower support tube
Note: Ensure that the mains lead, which goes
through the support tubes
jammed.
Note: Be sure to screw in the support tubes
,
as far as possible so the light is stable.
6
7
Place the support tube onto the base
screw it in tightly.
Loosen the lamp ring
Put the lampshade
fix the lampshade
Use a clean, lint-free cloth to insert the lamp
Screw the lamp
1
Ensure that it is positioned correctly.
Plug the mains plug
been professionally installed.
Your light is now ready to use.
Switching the light on / off
Use the ON / OFF foot switch
light on or off.
Changing the bulb
DANGER OF ELECTRIC
SHOCK!
First unplug the mains plug
CAUTION! DANGER OF BURNS DUE
TO HOT SURFACES!
First leave the light bulb to cool down completely.
Only replace the bulb
cooled down.
14 GB/IE
.
7
into the middle
5
and screw it in tightly.
7
,
,
is not
5
6
7
and
10
from the bulb socket
2
on the bulb socket
3
4
using the lamp rings
3
clockwise into the socket
into a socket that has
9
to turn the
8
from the socket.
9
once it has fully
1
Use a clean, lint-free cloth when replacing the
bulb
.
1
Turn the defective bulb
the bulb socket
Only use LED illuminants with a maximum
output of 7 W and E27 base.
Carefully screw the new bulb
into the socket
correctly.
Plug the mains plug
Maintenance and cleaning
SHOCK!
,
5
First unplug the mains plug
SHOCK!
.
For electrical safety, never clean the light with water
4
and
or other liquids, nor immerse it in water.
.
CAUTION! DANGER OF BURNS DUE
2
TO HOT SURFACES!
.
1
.
First leave the bulbs to cool down completely.
4
Do not use solvents, benzene or similar
substances. They could damage the light.
Only use a dry, lint-free cloth for cleaning.
Plug the mains plug
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
anticlockwise out of
1
.
4
clockwise
1
. Ensure that it is positioned
4
into the socket again.
9
DANGER OF ELECTRIC
from the socket.
9
DANGER OF ELECTRIC
into the socket again.
9
Publicidad
