Uline H-1024 Manual De Instrucciones página 3

CLINCH ADJUSTMENT
Loosen securing nut closest to body. Turn adjustment nut
clockwise to loosen clinch. Turn adjustment nut counter-
clockwise to tighten clinch. After adjusting, tighten
securing nut. (See Figure 5)
Figure 5
DEPTH ADJUSTMENT
1. Loosen front two screws with 4 mm Allen w rench.
(See Figure 6)
Figure 6
2. Push the body up and adjust to the desired depth.
(See Figure 7)
Figure 7
PAGE 3 OF 18
OPERATION CONTINUED
BASIC OPERATION
1.
2. Grasp the handle with one hand on box in line
3. For strongest closure, use staples close to the ends of
CLEARING A JAM
1.
2. Insert needle nose pliers or screw driver to clear jam.
3. Slowly release pusher back to position.
Insert the staples into the stapler following the
loading instructions.
with the desired staple location. There is a small
projection on either side of the magazine seat as an
aid in locating the position of the staple.
the box.
Pull pusher back and rotate to a locked position.
(See Figure 8)
(See Figure 9)
Figure 9
Figure 8
0323 IH-1024