Uline H-1024 Manual De Instrucciones página 4

TEETH REPLACEMENT
1. Loosen screws and nut with 8 mm spanner wrench
and 4 mm Allen wrench. (See Figure 10)
Figure 10
2. Remove the magazine assembly. (See Figure 11)
Figure 11
3. Loosen screws with 3 mm Allen wrench.
(See Figure 12)
4. Change teeth one at a time to prevent reverse teeth.
PAGE 4 OF 18
OPERATION CONTINUED
Figure 12
DRIVER REPLACEMENT
1. Loosen screw and nut with 8 mm spanner wrench
and 4 mm Allen wrench. (See Figure 13)
Figure 13
2. Remove the magazine assembly. (See Figure 14)
Figure 14
3. Loosen the set screw with 3 mm Allen wrench to
unlock the adjusting rod. (See Figure 15)
Figure 15
0323 IH-1024