Vito Agro VIMEDTD7A Manual De Instrucciones página 48

Maintenance and cleaning
Before start cleaning,
maintenance works:
▪ Place the tiller in a firm and steady surface.
▪ Turn off the combustion engine and allow it to cool
down;
To clean or service the tiller, just lean it back. If the
machine is turned sideways or forward, damage to the
combustion engine and other parts of the machine may
occur, which may cause costly repairs.
Allow the tiller to cool down in particular before
carrying out
transmission/ drive system, combustion engine,
exhaust manifold and muffler. Temperatures of 80 ° C
or even higher can be reached.
Direct contact with engine oil can be dangerous,
moreover, engine oil must not be spilled.
VITO recommends that you leave of the engine oil
fueling process to a specialist.
Frequently check the equipment, especially before
storage (for example, before the winter period),
regarding wear and damages.
For safety reasons, replace worn out or damaged parts
immediately so the unit is always in perfect working
conditions.
Cleaning:
In order to avoid fire hazards, the ventilation slots and
exhaust must remain completely clean and free of any
debris.
The tiller must be carefully cleaned after each use.
Release the debris inlaid with a wooden splint.
The lower part of the machine can be cleaned with a
high-pressure washer or a steam washer. Keep a
minimum distance of 1m and never point water jets
directly to the support/holders and sealing gaskets, in
particular, the sealing gasket between the transmission
crankcase and the guard plate.
Do not use aggressive cleaning products.
products may damage
compromising the safe operation of the tiller.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official dealer.
48
adjustment, repair
maintenance work
plastics and
If you lack the necessary knowledge and means, always
contact an official dealer.
and
Use only VITO-approved tools or accessories for this
tiller or technically identical parts. Not doing so may
result in personal injuries or damages to the device. In
case of doubt, you should contact an official dealer.
For safety reasons, the fuel system components (hose,
tap, tank, tank cap and connections/couplings) should
be inspected regularly regarding damage and leaks. If
necessary, they should be replaced by an official dealer.
Always keep warning and information stickers clean and
legible.
on the
Keep all nuts, split pins and screws well tightened in
order to ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately.
When replacing the tines, pay attention to the type of
tines and if they match. Only use VITO-authorized
versions.
Storage in case of longer stopping periods
Allow the combustion engine to cool down before
placing the machine in a closed room.
Never store the equipment with diesel in the tank inside
a building. Diesel vapours may come into contact with
flames or sparks and ignite.
Store the tiller in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment.
If you wish to empty the tank, for example before the
winter period, the fuel tank should only be emptied
outdoors.
Clean the equipment thoroughly before storage,
especially in winter.
operating mode.
Make sure the device is protected against misuse (for
example, by children).
Technical assistance
These
Your diesel tiller should only be serviced by the
metals,
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
Keep the device in a good