Stihl HSA 100.0 Manual De Instrucciones página 32

English
16 Maintenance
16.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
After every 50 hours of operation
► Lubricate the gearbox.
Every 12 months
► Have hedge trimmer checked by a STIHL
servicing dealer.
16.2 Lubricating the Gearbox
2
1
► Remove screw plug (1).
► If no grease is visible on the end of the screw
plug (1):
► Screw in the tube of STIHL gear lubri‐
cant (2).
► Squeeze 5 g of STIHL gear grease into the
gear housing.
► Unscrew the tube of STIHL gear lubri‐
cant (2).
► Insert and tighten the screw plug (1)
securely.
► Run the hedge trimmer for one minute.
The STIHL gear lubricant is evenly distrib‐
uted.
16.3 Sharpening the cutting blades
STIHL recommends you have the cutting blades
resharpened by a STIHL dealer.
WARNING
■ The teeth of the cutting blades are very sharp.
There is a risk of cutting oneself.
► Wear work gloves made of robust material.
32
► Switch off the hedge trimmer and remove the
battery.
► Use a STIHL flat file to sharpen each cutting
edge on the upper blade. The file only sharp‐
ens on the forward stroke. Maintain the pre‐
scribed sharpening angle,
► Turn the hedge trimmer over.
► Sharpen the remaining cutting edges.
► Deburr each cutting edge from below.
► Turn the hedge trimmer over.
► Deburr the remaining cutting edges.
► Use a damp cloth to remove the filing dust.
► Spray both sides of cutting blades with STIHL
resin solvent.
► Run the hedge trimmer for 5 seconds.
The cutting blades run. The STIHL resin sol‐
vent is distributed evenly.
► If you are unsure: Consult a STIHL authorized
dealer.
17 Repairing
17.1 Repairing the Hedge Trimmer
and Battery
The hedge trimmer, cutting blades and battery
cannot be repaired by the user.
► If the hedge trimmer or cutting blades are
damaged: Do not use your hedge trimmer and
contact your STIHL servicing dealer.
► If the battery has a malfunction or is damaged:
Replace the battery.
16 Maintenance
19.2.
0458-020-9801-A