Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
This instruction manual contains important in-
formation and must be read carefully by com-
petent persons prior to any handling, trans-
port, inspection or installation of this product.
Every care has been taken in the preparation
of the instructions and information; however,
it is the responsibility of the installer to ensure
the system complies with relevant national
and international regulations, especially safe-
ty. The manufacturer, Soler & Palau Sistemas
de Ventilación S.L.U. accepts no responsibility
for breakages, accidents or any inconvenience
caused by failure to comply with the instruc-
tions contained in this manual.
The fan units referred to in this manual
have been manufactured in accordance with
rigorous quality control and International
standard ISO 9001. Once the product has
been installed, this manual to be retained by
the end user.
TRANSPORT AND MANIPULATION
• The packaging used for this fan unit has
been designed to support normal trans-
porting conditions. The fan unit must al-
ways be transported in its original pack-
aging as not doing so could deform or
damage the product.
• The fan unit must always be transported in
its original packaging. Do not accept delivery
if the fan is not in its original packaging or
shows clear signs of having been damaged.
• The product should be stored in a dry place
in its original packaging, protected from
dust and dirt until it is installed in its fi nal
location.
• Do not place heavy weights on the packed
product and avoid impact damage.
• Any lifting equipment must be safe and of
suitable capacity for weight and size. Spe-
cial attention may be required to ensure
fan assembly does not distort or tilt as
weight distribution may vary.
• Never lift a product by pulling it by the
wires or terminal casing. Likewise, no
pressure should be applied on the propel-
ler, turbine or safety grid while manipulat-
ing the product.
STORAGE
Storage must be in a safe, fl at, controlled
environment to prevent damage, especially
from water, sand, dust, moisture, corrosion,
temperature. Recommend that duct connec-
tions (infl ow and outfl ow) are closed to avoid
dust/debris entering the equipment. These
data may also apply to an installed fan, which
is not put into operation for extended period.
IMPORTANT INFORMATION
FOR THE SAFETY OF
INSTALLERS AND USERS
• Installation must be carried
out by qualifi ed persons act-
ing in accordance with all
safety precautions applicable
and as required by law, reg-
ulations and standards in the
country applicable.
• All fan units are designed
and manufactured in accord-
ance with EC Directive. Safety
guard accessories are availa-
ble from S&P if required due
to specifi c installation.
EN
11
Publicidad
