cecotec CONGA WINDROID 880 SPRAYWATER CONNECTED Manual De Instrucciones página 43

How to charge the battery
Note
The WinDroid battery has a safety system which, in the event of a power failure, has a back-up
of up to 30 minutes. The approximate back-up time (30 minutes) will depend on the current
charge when the device stops receiving electrical power or on the previous work. Make sure
your battery is completely charged before starting the device (green light).
1. Turn off the switch, plug the power cord and the orange light will turn on, indicating it is
charging the battery.
2. When it is completely charged, the light will turn green.
Charging time is approximately 2 hours. It can vary depending on the charging conditions (fully
or not) and the product age.
How to assemble the cleaning cloth and ring.
Fig. 4
- Assemble the cleaning cloth onto the ring.
- Place the ring in the cleaning disc. Make sure it is properly placed to avoid leakages.
How to activate the safety measures.
- Before starting:
- To clean windows or glass doors without a balcony, you must place a safety warning for
the persons near the objects.
- After every use, check the safety rope does not show any damage or flaws. You must also
check the wire from the safety rope is properly secured and at the appropriate height.
-
Positioning the rope:
- Loosen the thread from the end of the rope and tighten it in the hole (7).
- Position the rope in the robot as shown in the figure. (Fig. 5)
- Secure the safety rope before using the robot, ensuring it is tight. Place the hook from the
other end of the rope to a fix and stable object at home to prevent risks. Male sure the rope
height is appropriate to prevent risks in case of accidental dropping.
How to pour water/glass cleaner
Fig. 6
- Open the hole which is sealed with a silicone tab.
- Pour the liquid. Use water or glass cleaner. Do not introduce any other liquid.
How to place the Conga WinDroid robot on the glass/window
- Hold down the On/off button and make sure the fan is activated.
- Put the robot onto the glass or window. Keep it 10 cm away from the window frame.
- Make sure the robot stays firmly on the glass before releasing it.
ENGLISH
43