Descargar Imprimir esta página

Dell EMC S4112-ON Serie Guia De Instalacion página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Power
To connect the switch to the applicable power source, use the appropriate power cable. An
AC power cable is included with the switch.
When installing AC or DC switches, follow the requirements of the National Electrical Code
ANSI/NFPA 70, where applicable.
The switch is powered-up when the power cable is connected between the switch and the
power source.
CAUTION: Always disconnect the power cable before you service the power
supply slots. The switch has multiple power cords. Before servicing, ensure all
power cords are disconnected.
CAUTION: On the AC switch, use the power supply cable as the main disconnect
device. Ensure that the socket-outlet is located/installed near the equipment and
is easily accessible.
NOTE: Module power is software controlled. You do not see module LEDs when
the switch powers up in ONIE.
Storing components
If you do not install your S4112-ON Series switch and components immediately, properly
store the switch and all optional components following these guidelines:
Storage location temperature must remain constant. The storage range is from -40° to
65°C (-40° to 149°F).
Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning
ducts.
Store in a dust-free environment.
NOTE: ESD damage can occur when components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the switch and its
accessories. After you remove the original packaging, place the S4112-ON Series
switch and its components on an anti-static surface.
13

Publicidad

loading