Walter ICECUT 250 Auto Manual De Instrucciones página 14

To operate the autofeed function turn on the mag drill and ensure it is set to the correct speed. With the
unit turned on, push the capstan lever towards the machine. Once in place, the autofeed is activated
and the spindle will begin to plunge.Once the drilling operation is completed, the spindle will
automatically retract until the cutter is free from the workpiece and the machine will turn off.
In the case where the spindle does not retract completely, deactivate autofeed by pulling the capstan
levers into the manual position and manually retract the cutter before turning the drill off.
Warning do not operate the autofeed function while tapping.
14