Publicidad
Idiomas disponibles
Idiomas disponibles
1) INTENDED USE
The intended use of this magnetic drill is to drill holes in ferrous metals. The magnet is used to hold the
drill in place whilst the drill is functioning. It is designed for use in fabrication, construction, railways,
petrochemical and any other applications when drilling ferrous metal. Any deviation from its intended
use will not be covered by warranty.
2) GENERAL SAFETY RULES
WARNING!
When using electric tools basic safety precautions should always be followed to reduce
the risk of fire, electric shock and personal injury. Failure to follow all instructions listed below, may
result in electric shock, fire and/or serious personal injury.
WORK AREA
Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
1.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable
2.
liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
Keep bystanders, children, and visitors away while operating a power tool. Distractions can
3.
cause you to lose control.
ELECTRICAL SAFETY
Grounded tools must be plugged into an outlet properly installed and grounded in accordance
1.
with all codes and ordinances. Never remove the grounding prong or modify the plug in any
way. Do not use any adaptor plugs. Check with a qualified electrician if you are in doubt as to
whether the outlet is properly grounded. If the tools should electrically malfunction or break
down, grounding provides a low resistance path to carry electricity away from the user.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
2.
There is an increased risk of electric shock if your body is grounded.
Don't expose power tools to rain or wet conditions. Water entering a power tool will increase
3.
the risk of electric shock.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet.
4.
Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of electric shock.
When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W".
5.
These cords are rated for outdoor use and reduce the risk of electric shock.
SAVE THESE INSTRUCTIONS
3
Publicidad
