Walter ICECUT 250 Auto Manual De Instrucciones página 12

8) GEAR SELECTION
The Icecut 250Auto magnetic drill is fitted with a 2-speed gearbox.
The gear is used to reduce the output speed when using larger cutters.
Slide Selector Position
High Speed /\
Low Speed \/
9) MAGNET DETECTION
It is advised that when working on thin material a packing piece should be used to increase the material
thickness under the magnet. Working on thin material without a packing piece will reduce the magnet
holding force.
It is advised that the drill is to be operated on ferrous material 12mm thick and above. Damage to the
magnet base, such as pitting, will affect the strength of the magnet holding force.
Kg
Level 1 Level 2
200/min 260/min
100/min 133/min
Slide Selector Position Up
Material Thickness in mm
Speed Controller Setting
Level 3 Level 4
320/min 380/min
166/min 199/min
Slide Selector Positon Down
12
Level 5 Level 6
440/min 500/min
232/min 265/min