Publicidad
Idiomas disponibles
Idiomas disponibles
4) SPECIFICATIONS
Maximum hole cutting capacity in mild steel (Ø X DoC) = 2-3/8" x 3"
(3" DoC requires 2-piece pilot pin 05-Z 032)
Arbor bore = MT2
Voltage
Normal full load
Electro Magnet
Size
Holding Force at 20°C with 25mm minimum plate thickness
The use on any material less than 25mm thick will progressively reduce the
magnetic performance. If possible, substitute material should be
positioned under the magnet and work piece to equate to a suitable
material thickness. If this is not possible, an alternative secure method of
restraining the machine must be used.
Total Load (magnet + motor)
Height - maximum extended
Height - minimum
Width (including capstan fitting)
Length Overall (including guard)
Net Weight
Product Code
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will earth back through the magnet and cause irreparable damage.
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE GUARANTEE
5) OPERATIONAL SAFETY PROCEDURES
READ BEFORE USING THE MACHINE
•
When using electrical tools, basic safety precautions should always be followed to reduce the risk of
electric shock, fire and personal injury.
•
Ensure the magnet is off before plugging in the machine.
•
Do not use in wet or damp conditions. Failure to do so may result in personal injury.
•
Do not use in the presence of flammable liquids, gases or in high risk environments. Failure to do so
may result in personal injury.
•
Before activating the machine, inspect all electrical supply cables (including extension leads) and
replace if damaged. Do not use if there are any signs of damage.
•
Only use extension cables approved for site conditions.
Overall Dimensions
Suitable only for a single phase 50-60Hz A.C. power supply
DO NOT USE ON D.C. SUPPLY
WARNING: THIS APPLIANCE MUST BE EARTHED!
Motor Unit
7
120V 50-60Hz
14A
0.53A
200mm long
98mm wide
1378kgs
14.53 amps
586mm
450mm
255mm
395mm
18.5Kg
Icecut 250 Auto (39-D 252)
Publicidad
