Publicidad
Idiomas disponibles
Idiomas disponibles
TECNO-GAZ
Grip installation
Connessione
scheda elettronica
Connessione video
LCD
Accessory manual
CAUTION – Make sure the grip and camera are firmly fitted. Risk
To install the sterilisable hand-piece, align it with the camera body and
push it upwards (5) and turn it until the 3 stops are fastened in the
respective holes on the hand-piece (6).
5
To remove the hand-piece from the lamp, simply press the three stops (7)
at the same time and pull the hand-piece (8) downwards.
7
2.4 CAMERA power connection
The wall camera control board must be powered at 24VDC, connecting the
connector terminals (+/-V, Earth) to the terminals of the power supply
board.
The wall control must be connected to the control board inside the dome
by means of the "OW" cable. Connect the "OW" cable of the Product to the
"OW" connector of the wall control board.
The LCD display screen must be connected to the Video/Audio cables of
the Product.
Depending on the type of camera, the cables to be connected are:
MA_001
01/09/15
Rev.0
Pag. 11 di 24
of falling.
6
8
EN
Publicidad
