Ubbink SolarMax 2500 Accu Instrucciones De Uso página 4

Operating Manual – SolarMax 2500 Accu
1
Intended use
This product is designed exclusively for private use in small garden ponds. Direct sunlight
is necessary to operate the pump. The battery is charged by direct sunlight. The pump is
switched on when the battery voltage is in the operational range. In darkness, the pump is
supplied by the battery for up to several hours, depending on the charge level. The pumping
capacity can be altered via a potentiometer.
Electronic circuitry protects the battery from deep discharging, overcharging and short
circuits.
Caution! The plug connectors are protected from inverse polarity, so do not use force when
connecting.
Installation and commissioning
1. Completely unroll the pump connecting cable.
2. Screw the adapter for the extension pipe on to the pump outlet.
3. Connect the appropriate number of extension pipes and attach the selected fountain jet. Attach the extension pipe and pipe adapter to the pump.
Vulkan: Make sure the spray head is not positioned too far above the water surface to
maximise the height of the Vulkan fountain.
Water bell: The jet attachment should be placed well above the water surface.
The size of the water bell can be adjusted by pressing down or lifting up the top part
of the jet. The larger the gap for the water outlet, the smaller the water bell.
Bubbler jet: Make sure that the six deflector openings of the spray head are
always under wa.
4. Place the pump in the pond. Avoid a position directly on the bottom of the pond, because here the pump will suck in a lot of dirt and become quickly soiled.
5. Put together the solar module retainer (pipes and earth spike) and then attach it to the back of the module.
6. Connect the battery box plug to the solar module and tighten the retaining ring.
4