Publicidad
Idiomas disponibles
Idiomas disponibles
Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel indicate the
selected settings.
Air Conditioner Controls
6
1
Power
WiFi
Delay
8
Solid light indicates WiFi connected
Blinking light indicates connecting
See Appliance Communication section in this manual
1. Power Pad
Turns air conditioner on and off. When turned on,
the display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on
the Delay timer. Shows the Set temperature while
setting the temperature in Quiet, Cool or Eco
modes.
3. Temp and Delay Increase + /Decrease - Pads
can be set in Quiet, Cool and Eco mode.
4. Mode Pad
Eco or Quiet mode.
5. Fan Speed Pad
In Cool or Eco
Auto, High, Med or Low on the unit.
In Fan Only
High, Med, or Low on the unit.
In Quiet mode, the fan speed will automatically be
set to Low (indicator is Auto).
6. Delay Pad
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad. Each touch of the Increase
+
-
/ Decrease
pads will set the timer in 1-hour
intervals.
49-5000765 Rev. 0
2
Cool Fan
Eco Quiet
Mode
Temp | Time
4
3
Fan Only, Cool,
7
Auto
Low Med
High
Speed
Filter
5
To review the remaining time on the Delay timer,
press the Delay
-
Decrease
pads to set a new time if desired.
To cancel the timer, press Decrease
the set time '- -' .
7.
Filter Reset Pad
This feature automatically notifies you that the air
filter must be cleaned. The indicator light will come
on after 250 hours of operation. Clean the air filter
(refer to page 7), place it back in the front panel,
and press the Filter Reset pad. The light will go off.
8. WiFi Connect Pad
Enables connection of the air conditioner to the
home WiFi. Download SmartHQ App for details at:
GEAppliances.com/connect.
9. Sabbath Mode
Press and hold both the Power and Speed buttons
on the user interface for 3 seconds to start Sabbath
Mode.
When unit is in Sabbath mode, all single button
presses or app input will not be operational until unit
has exited Sabbath mode. The panel will show 'SA'.
Press the Power and Speed buttons simultaneously
Sabbath mode if no buttons are pressed within 96
hours of initiation.
1
Power
5
Speed
3
4
Mode
6
Quiet
Delay
Remote Control
+
Increase
/
–
pad until
5
Publicidad
