Publicidad
Idiomas disponibles
Idiomas disponibles
Using the Air Conditioner
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions.
Control Panel Lights On/Off Feature
This air conditioner has a control panel lights on/off
feature where its lights will turn off when there is no
activity with the controls for over one minute. To wake up
the controls, press any pad on the controls and the lights
will come on to show the previous settings.
Control Panel Sound On/Off Feature
This air conditioner has a control panel sounds on/off
feature where the sounds that occur when a button on
the user interface is touched can be turned on or off.
This feature is turned on by default, meaning that the
air conditioner will make a sound when any button is
Remote Control
To ensure proper operation, aim the remote control at
the signal receiver on the air conditioner.
The remote control signal has a range of up to 20 feet.
Cool Mode
Temperature Increase
pads to set the desired temperature between 64°F and
86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off and
also change operating speeds to keep the room at
the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler. Set the
thermostat at a higher number and the indoor air will
become warmer.
Eco Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature.
NOTE: the fan may continue to run for a short time or
may pulse intermittently after the compressor cycles off
to sample the room air.
Fan Only Mode
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
Auto Fan Speed
Set to Auto for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with
the set temperature.
6
Low, Med, High or Speed for
+
/ Decrease
It must not be used when the outdoor temperature is
below freezing (32°F).
To turn this feature off, press and hold the Delay pad, on
the unit, for 5 seconds. The unit will beep to signal the
successful toggle of the feature on and off.
pressed on the user interface. To turn this feature off so
as to make the button presses silent, press and hold the
Filter button on the user interface for 5 seconds. The air
conditioner will beep to signal the successful toggle of
this feature on and off.
Make sure nothing is between the air conditioner and
the remote control that could block the signal.
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
NOTE: If the air conditioner is off and is then turned on
-
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
OFF—The fan runs all the time, while the compressor
cycles on and off.
temperature cannot be entered. The room temperature
will appear in the display.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling, the
fan speed will automatically decrease.
49-5000765 Rev. 0
Publicidad
