PWSG 3600 PSI SHORT TRIGGER HANDLE
FOR WESTINGHOUSE PRESSURE WASHERS
WARNING
User must read and understand the operator's manual for their pressure
washer before using this accessory to reduce the risk of injury. Fits
most pressure washers. Before using this attachment, make sure it is
compatible and is correctly installed. Risk of fluid injections. Do not point
at people, pets, electrical devices, or the unit itself. Wear eye protection
designated to conform with ANSI Z87.1. Before adding, replacing, or
modifying accessories, turn off the pressure washer, release the water
pressure in the trigger handle, and lock the trigger handle's lock out (if
one is provided with your pressure washer). Use only with cold water
and only outdoors. Store the accessory indoors.
INSTALLING THE TRIGGER HANDLE
See Figure 1.
l Thread the collar of the high pressure hose clockwise onto the trigger
handle's coupler.
l Pull on the hose to be certain it is secure. Be careful not to cross-thread.
USING THE TRIGGER HANDLE
See Figure 2.
Always hold the trigger handle with both hands for greater control and safety.
l Pull back on the trigger to begin operation.
l To stop the flow of water, release the trigger.
To lock the trigger:
l Move the lockout into the slot on the handle.
To unlock the trigger:
l Move the lockout into the slot on the handle.
05000416-0 12/22 (REV:01)
FIG. 1
A - High pressure hose (manguera de alta presión, tuyau haute pression)
B - Collar (collar, collier)
FIG. 2
C
A - Lock out (bloqueo de seguridad, verrou de sécurité)
B - Slot (ranura, fente)
C - Trigger (gatillo, gâchette)
Service Hotline: (855) 944-3571
777 Manor Park Drive, Columbus, OH 43228
and Westinghouse are trademarks of Westinghouse Electric Corporation.
Used under license by MWE Investments, LLC.
© 2022 MWE Investments, LLC All Rights Reserved.
B
A
B
A