Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION & PREPARATION
ATTIRE:
Proper attire is essential to your safety. It is advised to utilize whatever
means necessary to protect eyes, ears, and skin. Additional safety attire
(such as respiratory mask) may be required when using detergent cleaning
agents with this washer.
SETUP:
1. This unit should only be placed on a level surface to ensure proper lubrication
for the water pump while operating. NEVER spray water directly on the unit!
2. Do not place unit in an area:
a. where there is evidence of oil or gas leaks.
b. where flammable gas vapors may be present.
3. Do not allow the unit to be exposed to rain, snow or freezing temperatures.
If any part of the unit becomes frozen; excessive pressure may build up
in the unit which could cause it to burst, resulting in possible serious injury
to the operator or bystanders.
4. Before each use, be certain the oil level is in the center of the sight glass.
If low, fill with pump oil. DO NOT OVERFILL!
WALL MOUNT OPTION:
POWER CORD CONNECTION:
1. Make certain the motor switch is in the "OFF" position.
2. Ensure electrical supply is identical to the specifications listed on the
pressure washer data plate.
3. GROUNDING INSTRUCTIONS: This product must be grounded. If it should
malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This product is equipped
with a cord having an equipment-grounding conductor. The plug must be
plugged into an appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
4. DANGER: Improper connection of the equipment-grounding conductor
can result in a risk of electrocution. Check with a qualified electrician or
service personnel if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician. Do not use any type of adaptor
with this product.
5. GROUND FAULT CIRCUIT INTERRUPTER PROTECTION:
a. 1502/2503: If this pressure washer is provided with a Ground Fault
Circuit Interrupter (GFCI) built into the plug or the power supply cord, test
the GFCI each time it is plugged into an outlet according to instructions
on the GFCI. DO NOT use the pressure washer if the test fails! The
GFCI provides additional protection from the risk of electric shock.
Should replacement of the plug or cord become necessary, use only
identical replacement parts that include GFCI protection.
b. 3004: If this pressure washer is not provided with a GFCI, this pressure
washer should only be connected to a receptacle that is protected by
a Ground Fault Circuit Interrupter (GFCI) to comply with the National
Electric Code (NFPA 70) and to provide additional protection from the
risk of electric shock.
CA Electric Operator's Manual
SEE PAGE 19.
WARNING: RISK OF EXPLOSION!
DO NOT OPERATE UNIT IN AN AREA
WHERE FLAMMABLE GAS VAPORS MAY
BE PRESENT. AN ELECTRIC SPARK MAY
CAUSE AN EXPLOSION.
RISK OF BURSTING!
DO NOT STORE / OPERATE UNIT IN A
FREEZING ENVIRONMENT.
DANGER: RISK OF
ELECTROCUTION!
THIS UNIT MUST BE CONNECTED TO A
PROPERLY GROUNDED OUTLET. DO NOT
USE AN ADAPTER OR REMOVE THE THIRD
GROUNDING PRONG.
WARNING: RISK OF
ELECTROCUTION!
T O R E D U C E T H E R I S K O F
ELECTROCUTION, KEEP ALL CONNECTIONS
DRY AND OFF THE GROUND. DO NOT
TOUCH PLUG WITH WET HANDS.
11
Publicidad
