Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING CONTINUED
Turning the System O
To turn your controller o , press the
and OFF is displayed on screen. To return the controller to auto
programming mode, press the
immediately return to auto programming mode and will display the
time and battery-life indicator.
Manual Watering
Manual Watering allows the user to test each station or a program
for a speci ed run time. The weather sensor condition (if used) will be
disregarded in this mode.
1.
Make sure the controller is in idle mode. Press and hold the
button until the
icon is displayed.
2. The station number will be displayed in the lower le side of the
display along with the run time.
3. Use the
and
buttons to select the desired station and
the
and
buttons to set the manual watering time for the
station shown.
button until the
icon
button. The controller will
4. To manually activate a program, press the
letter (A, B, or C) will show on the screen. If a di erent program
is needed, press the
button until the desired program is
displayed.
5. To stop the Manual Watering cycle, press the
time is reduced to zero.
6. Press the
button to proceed to the next programming function
or allow controller to return to idle mode.
NOTE:
• Pressing the
or
running in Manual Watering mode will modify the
irrigation time for that station.
• Pressing the
button when a station is running in
Manual Watering mode will stop irrigation on the
current station and advance to the next station.
• Pressing the
button when a station is running in
Manual Watering mode will stop irrigation on the
current station and revert to the previous station.
EN
button. The program
button until the
buttons when a station is
10
Publicidad
