Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING THE NODE
The NODE can easily be mounted on any Hunter plastic valve. A
specially designed valve mounting clip makes installation a snap. A
protective rubber cover is provided to prevent dirt from accumulating
on the face of the NODE.
To Mount the NODE to a Valve (Figure 1)
. Screw the Hunter DC latching solenoid (P/N
the valve bonnet.
. Set the small open end of the NODE holder on top of the solenoid.
. Set the NODE controller into the large open end of the
NODE holder.
Figure 1
) into
NODE holder
CONNECTING A WEATHER SENSOR
A Hunter Mini-Clik
or Wired Rain-Clik
®
to the NODE. The purpose of this sensor is to stop watering when
weather conditions dictate.
NOTE: When the Wired Rain Sensor is interrupting
the watering, the display will show the System O
icon
, "OFF" and
1.
Cut the yellow wire loop attached to the NODE at approximately
the middle of the loop.
2. Remove approximately ½" (13 mm) of insulation from each wire.
Attach one yellow wire to each of the wires of the weather sensor.
You can mount the rain sensor up to 100
controller (18 AWG/1 mm minimum wire size).
3. Secure wire connections with waterproof connectors.
Hunter Model Mini-Clik
EN
rain sensor can be connected
®
on the display.
(30 m) from the NODE
®
6
Publicidad
