Publicidad
Idiomas disponibles
Idiomas disponibles
1. Safety
! Safety Information
To ensure safe operation and service of the Tester,
follow these instructions. Failure to observe warnings
can result in severe injury or death.
- This meter is designed to be used by skilled
persons and in accordance with safe methods of
work.
- Avoid working alone so assistance can be
rendered. If the operators safety can not be
guaranteed, the Tester must be removed from
service and protected against use.
- Prior to usage ensure perfect instrument function
(e.g. on known voltage source) before and after the
test.
- Do not connect the instrument to voltages higher
than 750V.
- Do not open the battery cover before take off from
voltage source.
- The safety can no longer be insured if the
Tester :
• shows obvious damage • does not carry out the
desired measurements • has been stored for too
long under unfavorable conditions • has been
subjected to mechanical stress (i.e. during
transport).
- All relevant statutory safety regulations must be
adhered to when using this instrument.
- The Tester may no longer be used if one or several
functions fail or if no functionality is indicated or the
Tester looks damaged.
- When using this Tester, only the handles of the
probes may be touched do not touch the probe tips
(metal part).
- Do not use the Tester if the Tester is not operating
properly or if it is wet.
- Use the Tester only as specified in the Instruction
card including environmental conditions and the
usage in dry environments must be followed or the
protection by the Tester might be impaired.
- Use extreme caution when working around bare
conductors or bus bar. Contact with the conductor
could result in an electric shock.
- Use caution with voltages above 50V AC rms or
110V DC. These voltages pose a shock hazard.
- The voltage marked on this meter are nominal
voltages or nominal voltage ranges and that this
meter is only to be used on installations with the
specified nominal voltage or nominal voltage ranges.
- ELV indicator and internal sounder are not to be
used for measuring purposes.
- Verify the meter operation by measuring a known
voltage and by connecting the test probes together,
before use it. If no response, replace the battery
first or have the meter services.
1
EN
Publicidad
