Kärcher SP 16.000 Dual Manual Del Usuario página 10

Improper use
ATTENTION
Risk of damage due to frost!
Operation during frost may damage the device.
An incompletely emptied device can be damaged by
frost.
Do not operate the device during frost.
Protect the device from frost.
ATTENTION
Risk of damage during continuous operation!
The device is not suitable for continuous operation.
Do not operate the device continuously for long periods
(e.g. continuous circulation operation in ponds) or as a
stationary installation (e.g. as a water lifting system,
fountain pump).
Note
The manufacturer accepts no liability for possible dam-
age caused by improper use or incorrect operation.
Hazard levels
DANGER
● Indication of an imminent threat of danger that will
lead to severe injuries or even death.
WARNING
● Indication of a potentially dangerous situation that
may lead to severe injuries or even death.
CAUTION
● Indication of a potentially dangerous situation that
may lead to minor injuries.
ATTENTION
● Indication of a potentially dangerous situation that
may lead to damage to property.
Environmental protection
The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic appliances contain valu-
able, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential threat to human health and the environ-
ment. However, these components are required for the
correct operation of the appliance. Appliances marked
by this symbol are not allowed to be disposed of togeth-
er with the household rubbish.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.com/REACH
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
10
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Device description
See graphics page for illustrations
Illustration A
Carrying handle
1
Power supply cable with plug
2
Automatic venting device
3
Quick-Connect hose connection
4
Pump connecting piece G 1 ½ (1", 1 ¼" and 1 ½"
5
hose connection and G 1 ½ thread)
*Pump connecting piece G 1 (3/4" and 1" hose con-
6
nection and G 1 thread)
* Check valve
7
G 1 threaded connection
8
Connection nozzle (G 1 ½ thread)
9
Setting for filter basket
10
Filter basket
11
Lock (float switch)
12
Height adjustment (float switch)
13
Float switch
14
*Not included in the scope of delivery.
DANGER
Risk of electric shock and risk of injury!
The device contains electrical and mechanical compo-
nents.
Always disconnect the device from the power supply
before assembling, disassembling or cleaning.
Note
The shorter the hose length and larger the hose diame-
ter, the higher the delivery rate.
To avoid clogging the pump, use a pre-filter for hose di-
ameters smaller than 1 ¼".
The pump connection is equipped with a plug system
(Quick-Connect).
The connection nozzle with pump connecting piece
G 1 ½ and the G1 threaded connection are supplied un-
installed with the device.
Note
Hoses with a diameter of 1", 1 ¼" and 1 ½" can be con-
nected to the pump connecting piece G 1 ½.
A sufficiently large hose diameter must be selected and
the G 1 ½ pump connecting piece must be shortened at
the grooves so that the required particle size can be
pumped. A large hose diameter is also recommended
for smaller particle sizes to allow a high flow volume.
Connecting a hose to the pump when using a 1",
1 ¼" or 1 ½" hose:
English
Warranty
Initial startup