Assembly; Inserting And Removing The On-Board Computer - Bosch Nyon Instrucciones De Servicio Originales

Deactivate and remove the on-board computer
u
if you are fitting or working on the holder. This
avoids malfunctions/misuse.
Deactivate and remove the on-board computer
u
if you are fitting or removing the securing
screw. This avoids malfunctions/misuse.
Inserting and removing the on-board
computer
A
(5)
1
(20)
(4)
B
1
(9)
(4) Holder for on-board computer
(5) On-board computer
(9) Release mechanism
(18) Locking screw for on-board computer
(19) Drive unit contacts
Bosch eBike Systems
2
(18)
2
(19)
(20)
A)

Assembly

(20) Operating unit contacts
A) For mounting on the handlebars, custom solutions are pos-
sible even without the use of the handlebar clamps.
To insert the on-board computer (5), first fit the
lower section into the holder (4) and then press it for-
ward until you can feel that the on-board computer is
fixed in place. Make sure that the on-board computer
is firmly fixed in place.
To remove the on-board computer (5), press on the
release mechanism (9) and take out the on-board
computer from above.
When you park up the eBike, remove the on-
u
board computer.
It is possible that the release mechanism may become
jammed by a screw. To rectify this, remove the
holder (4) from the handlebars. Put the on-board
computer in the holder. Screw the locking screw (18)
3
(M3 thread, 5 mm long) from below into the corre-
sponding thread in the holder. Mount the holder back
on the handlebars.
Note: The locking screw is not designed to prevent
theft.
English – 11
1 270 U20 BN2 | (19.05.2020)