Technical Data; Assembly; Operation; Initial Operation - Bosch Intuvia Manual Original

Ocultar thumbs Ver también para Intuvia:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English–5

Technical Data

On-board computer
Article number
Max. charging current,
USB connection
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, approx.
This device is in compliance with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device must not cause harmful interference, and
(2) this device must accept any interference that is received, in-
cluding interference that may cause undesired operation.
This device is in compliance with CAN ICES-3(B)/NM B-3(B).
Bosch eBike system uses FreeRTOS (see www.freertos.org)

Assembly

Inserting and removing the battery pack
To insert or remove the battery pack in/from the eBike,
please read and follow the battery pack operating instruc-
tions.
Inserting and removing the on-board computer
4
3 On-board computer
4 Holder for on-board computer
15 Lock latch for on-board computer
16 Locking screw for on-board computer
1 270 U20 XBI | (21.4.16)
Intuvia
1 270 020 906/909
mA
V
°F
+23...+104
°F
+14...+122
°F
+32...+104
IP 54 (dust and splash
water protected)
lb
3
15
16
To insert the on-board computer 3, slide it from the front
into the holder 4.
To remove the on-board computer 3, press the lock latch
15 and slide the on-board computer toward the front out of
the holder 4.
500
 Remove the on-board computer when you park the
eBike.
5
It is possible to secure the display unit against removal in
the holder. To do so, remove the holder 4 from the handle-
bar. Put the display unit in the holder. Screw the locking
screw 16 (thread M3, 8 mm long) from below into the
thread provided in the holder. Attach the holder back onto
the handlebar.
0.3

Operation

Requirements
The eBike system can only be activated when the following
requirements are met:
– A sufficiently charged battery pack is inserted (see the
operating instructions for the battery pack).
– The on-board computer is properly inserted into the
holder.
– The on-board computer is properly connected.

Initial Operation

Switching the eBike System On/Off
Options for switching on the eBike system:
– If the on-board computer is already switched on when
inserted into the holder, then the eBike system will be
switched on automatically.
– When the on-board computer and the eBike battery
pack are inserted, briefly press the On/Off button 5 of
the on-board computer once.
– When the on-board computer is inserted, press the
On/Off button on the battery pack.
Once it is switched on, the eBike system is in the "OFF"
mode. Select the desired assistance level and take off.
The drive is activated as soon as you put pressure on the
pedals. The assistance level depends upon the on-board
computer settings.
As soon as you stop pedaling when in normal operation, or
as soon as you have reached a speed of 20 mph, the assis-
tance from the eBike drive unit is switched off. The motor
assistance is automatically re-activated as soon you start
pedaling again and the speed is below 20 mph.
Bosch eBike Systems

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1 270 020 906/909

Tabla de contenido