Refsta TOLOMEO Manual De Uso página 34

category III conditions, the means for
disconnection must be incorporated in the
fixed wiring in accordance with the wiring
rules. This is also applicable for appliances
with a supply cord and plug when the plug is
not accessible after installing the appliance.
Using an omnipolar switch with a contact
separation of at least 3 mm fitted in the fixed
wiring will fulfil this requirement.
Ÿ
The supply cord must hang freely and should
not be fed through a drawer.
Ÿ
For connecting, use an approved cable with
the correct cable diameters appropriate for
the connection. The cable casing should be
made of rubber (preferably of the H05V2V2
or H07V2V2 type).
Ÿ
Before connecting the appliance,make sure
3. DESCRIPTION
2
3
1
1. Cooking zone front 210 x 190 mm / 2.1 kW (boost 3.0 kW)
2. Cooking zone rear 210 x 190 mm / 2.1 kW (boost 3.0 kW)
3. Connected cooking zones 210 x 390 mm / 3.7 kW
4. Extractor
5. Control panel
34 EN
the voltage indicated on the rating plate
conforms to the voltage in your power mains.
Ÿ
The connection should be adjusted to the
current and fuses.
Ÿ
The appliance should not be connected to
the mains via a multi-plug adapter or
extension cable, as the safe use of the
equipment cannot be guaranteed.
Ÿ
After installation, the parts carrying electrical
current and insulated parts shall be
protected against contact.

Ÿ
WARNING!
Failure to use screws or fasteners for
installation as described in the installation
instructions may result in electric shock.
4
5
2
3
1