Refsta TOLOMEO Manual De Uso página 50

13. TROUBLESHOOTING

WARNING!
If you see a crack in the glass top (however
small), switch off the hob immediately and
disconnect it from the power mains. Contact the
service department.
Symptom
The display lights up when the
hob is activated for the first
time.
The fan runs on for several
minutes after the hob has
been switched off.
A slight smell is noticeable the
first few times the hob is used.
The pans make a noise while
cooking.
You have switched on a cooking
zone, but the display shows u.
A cooking zone suddenly stops
working and you hear a signal.
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the
hob is switched on.
50 EN
Odour filter (recirculation use)

Depending on type, filter can be or cannot be
regenerated. Refer to the leaflet provided with
the filter.
If the appliance does not work properly, this
does not always mean that it is defective. Try to
deal with the problem yourself first by checking
the table below. You can also take a look on our
website for more information. If the problem
continues, contact the service department.
Possible cause
This is the standard set-up
routine.
The hob is cooling.
The new appliance is heating
up.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking,
or has a to small diameter.
The time that has been set for
the timer has ended.
There is no power supply due to
a defective cable or a faulty
connection.
The hob has been wrongly
connected.
WARNING!
Solution
Normal operation.
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate the
kitchen.
At high levels this is perfectly
normal for some pans. It will not
damage either the pans or the
hob.
Use a suitable pan.
Touch the left or right timer key
to stop the alarm.
Check the fuses or the electric
switch (if there is no plug).
Contact a professional installer.