Publicidad
Idiomas disponibles
Idiomas disponibles
Height Adjustment
for Head Support and Shoulder Harnesses
see images
-
3
7
Please adjust the head support and check if the shoulder harnesses
are at the correct height according to
!
When used in rear facing mode, the shoulder harness height must
be even with or just below the top of child's shoulders.
!
When used in forward facing mode, the shoulder harness height
must be even with or just above the top of child's shoulders.
!
When used in booster mode, the shoulder belt guides must be even
with child's shoulders.
5
To adjust the headrest heights, press the adjustment lever first then pull
or push down the head support until it clicks into one of the 14
positions.
7
!
The shoulder space expands as the head support height is adjusted
to the positions from 11th to 14th.
Recline Adjustment
see images
-
8
9
Press the recline adjustment button to adjust the enhanced child
restraint to the desired position.
There are 5 recline positions that can be used for rear facing, forward
facing, and booster modes.
Base Installation
see images
-
10
16
1. Insert ISOFIX guides to assist with installation.
2. Press the ISOFIX adjuster button to extend the ISOFIX.
20
3
&
4
&
5
&
6
&
7
3
&
8
9
9
10
13
3. Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. The colors of the indicators on both
ISOFIX connectors should be completely green.
!
Press the ISOFIX adjustment buttons again while pushing the seat
back until it comes in contact with the vehicle seat backrest.
4. After attaching the ISOFIX, pull the load leg downward to floor.
When the load leg indicator shows green, the load leg is installed
correctly.
5. Squeeze the load leg releasing button, then adjust the load leg
length.
!
Always make sure the support leg has direct contact with the floor
4
and is in locked position even when the child is not in it.
Removing the seat
1. To remove from the vehicle press the ISOFIX adjuster button and
pull the base back from the seat. Then press and release the
connectors from the vehicle's ISOFIX.
2. To prevent damage during transit, press the ISOFIX adjuster button
-1
and fold the connector completely.
16
Using in the Rear Facing Mode
(Child height 40cm-105cm/Child weight
18kg/infant - 4 years old)
see images
!
Install the enhanced child restraint on the rear vehicle seat and then
put the child in the enhanced child restraint.
Press the rotating button to rotate for easier side loading/unloading of
the child, then rotate the seat to the rear facing position.
!
Press the rotating button on either side to rotate the enhanced child
restraint.
-1
13
-2
-2
14
-3
14
-
17
24
-1
14
-1
-2
15
15
-2
16
&
17
18
21
Publicidad
