Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 1
Fig. 2
Fig. 3
ASSEMBLY
Your Evolution H320 needs some minor assembly
before use. If you have the petrol engined machine,
complete all assembly before filling the engine with
0.4L of the recommended service oil.
1. Attaching the Extension Handle – H320-P
Note: The handle extension has an anti-vibration
hand grip which helps the operator to manage the
vibration transmitted by the machine to the hand/
arm of the operator. The Extension Handle should
be fitted for operational purposes, but can be folded,
during transportation or storage. Removing the
bottom four screws and loosening the top four screws
allows the handle extension to be folded for ease of
transportation.
•
Carefully slide the middle handle section over the
two lower handle brackets and align the four holes
in the middle handle with the four vertical thredded
holes in the lower brackets.
•
Insert the four M10 x 20 screws through the middle
handle and the upper handle brackets.(Fig. 2)
•
Tighten all four screws securely using the alan key.
2. Assembling/attaching the Handle – H320-E
Note: The H320-E Handle consists of four (4) main
parts:
• Lower handle (factory attached to the machine).
• Middle section.
• Upper section with 'On/Off' safety switch.
• Cross-bar/cable store.
The two long screws are used to attach the cross-bar/
cable store and the middle section of the handle to the
pivoting lower handles.
• Carefully position the cross-bar cable store into its
service position.
Note: The cable pins should face rearwards.
• Carefully slide the Middle Section over the lower
handles and align the holes.
• A washer must be used bewteen the screw & the
handles. (Fig. 1)
• Insert the long screws through the holes in the
middle handle, through the holes in the lower
handles and screw them into the captive nuts in the
cross-bar/cable store. (Fig. 3)
• Tighten these screws securely using the alan key.
www.evolutionpowertools.com
13
Publicidad
