Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 8
Fig. 9
Fig. 10
16
Starting the H320-P
• Fill the fuel tank with petrol. The fuel tank filler filter
has a red plastic insert to mark the max fuel level.
Do not allow fuel to raise above this mark.
• Turn the fuel tap lever to the 'On' position. (Fig. 6)
• Set the choke lever to the 'Choke On' position.
(Fig. 7)
• Press the engine ignition rocker switch to the 'ON'
(I) position. (Fig. 8)
• Set the throttle lever to maximum. (Fig.9)
• Steady the H320 by holding the operating handle at
a convenient point.
• Use your other hand to grip the recoil starter cord
handle. (Fig. 10)
• Pull the recoil starter cord slowly until resistance is
felt indicating that the starter is engaged.
• When resistance is felt pull the cord sharply.
• Continue this procedure until the engine starts.
• The engine unit may rev (hunt) for a short period
until the engine is up to temperature.
• Usually the choke can be returned to the 'off'
(run) position almost immediately when the
engine fires up, but this will depend upon ambient
temperatures, operating conditions etc. and
operator discretion will be required.
• Under some circumstances choke may be needed
even when the engine is warm from a previous
operating cycle. If you experience difficulty in
starting a warm engine:
• Set the choke to the 'on' position (right).
• Pull the recoil starter once.
• Return the choke to the 'off' (run) position (left).
• Pull the recoil starter until the engine fires.
•
Note: The H320-P will begin to vibrate and travel
as soon as the engine is started. The operator
should ensure due diligence when starting this
machine.
Stopping your H320-P Engine
• Press the engine ignition rocker switch to the 'OFF'
(0) position.
• Close the fuel tap.
www.evolutionpowertools.com
Publicidad
