Publicidad
GB
At least 2/3
Machine location when operating on edges
Max 20°
or 36%
Tipping angle on side slopes
Max 20°
or 36%
Driving on slopes
WARNING
Safety When Driving
Driving near an edge
Tilting
Make sure that the work site is safe. Wet and loose earth reduces manoeuvrability especially
on sloping ground. Always observe particular caution on sloping and uneven terrain.
WARNING
Never work on slopes that are greater than the capability of the machine. Maximum slope of
the machine in operation is 20° (depending on condition of the ground).
The tilting angle is measured on a hard, level surface with the machine stationary. Vibration
switched OFF and all tanks full. Remember that loose ground, vibration switched ON, and
Never leave the machine unattended with the engine running.
Where possible, avoid all driving across a slope. Instead, drive up
and down on sloping ground.
10
Publicidad
Capítulos
