Publicidad
Produktgruppe 19
5 von 18
Blende an Arbeitsplatte montieren, siehe Abb. 5
Blende von oben in Befestigung schieben.
Gefahr!
Elektrische Sicherheitsprüfung durchführen.
de
en
Parts required
Quantity
Mat. no.
1
05090530
1
06694490
1
06889690
Fitting instructions for a washer-dryer stack with a W 300, W 400, W 500, W 2000 or W 3000 series
washing machine (with slanted fascia, without ComfortLine fascia) in combination with a T 200 or
T 4000 series dryer (without ComfortLine fascia)
Danger!
Before any service work is commenced, the machine must be disconnected from the mains.
Even with the machine switched off, mains voltage may be applied to some components.
Note
Service and repair work should only be carried out by suitably qualified persons in accordance with all
appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in
accordance with all appropriate legal requirements, accident prevention regulations and valid standards.
Washing machine lid and lid holder removal, Fig. 1
Remove the screw caps.
Loosen the lid screws by approx. 5 turns and press them in to release the retaining clips.
Lift the lid at the front, slide it to the rear and remove it.
Remove the screws from the two rear lid holders.
Slide the holders to the side and remove them.
Fitting washer-dryer stacking kit on washing machine, Fig. 2
Push the shelf in slightly to release it. Pull out the shelf to its end stop. Lift the shelf slightly and pull it
forwards. Tilt the shelf downwards and remove it.
Lay the stacking kit in position on the washing machine and align it with the appropriate holes.
Secure the stacking kit on the washing machine casing at the rear with two M 4 X 11 raised head screws
with toothed washers and at the front with four 4.2 X 9.5 raised head screws with washers.
Refit the shelf.
21.06.2006
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Washer-dryer stack kit WTV 405
Washer-dryer stack kit WTV 407 (lotus white)
Washer-dryer stack kit WTV 419 (stainless steel)
M.-Nr. 05091087
Publicidad
