Publicidad
Idiomas disponibles
Idiomas disponibles
5.1. LOCATION.
The inverters of the
EQX2-HT
enclosure with IP65 degree of protection, suitable for indoor and
outdoor installations. The following factors should be taken into
account when selecting an installation location for the inverter:
The wall on which the inverters are mounted must be able to
1.
support the weight of the inverter.
The inverter must be installed in a well-ventilated environment.
2.
Make sure that the inverter is not exposed directly to strong
3.
sunlight to avoid operation at excessive temperatures.
The inverter should be installed in a place sheltered from
direct sunlight and rain.
Install the inverter at eye level for easy reading of the data on
4.
the screen and better maintenance.
The ambient temperature of the place where the inverter is
5.
installed must be between -30ºC and +60ºC.
The surface temperature of the inverter can reach up to 75ºC.
6.
To avoid the risk of burns, do not touch the inverter during
operation and install it out of the reach of children.
5.1.1. Installation location.
We recommend installing inverters indoors. However,
if there is no choice but to install outdoors, shows recom-
mended locations, as well as those to avoid:
Fig. 33. Recommended locations for the inverter.
Do not store flammable and/or explosive materials
near the inverter.
Warning
5.1.2. Recommended installation distances.
Installation angle and
stalled on a vertical surface and that it keeps the following min-
imum safety distances with respect to other elements for optimal
ventilation, as shown in :
Fig. 34. Recommended installation distances.
Dimensions
A
B
5.2. ASSEMBLY PROCESS.
Steps:
72
series have been designed with an
spacing: Check that the inverter is in-
Distance (mm)
500
300
5.3. ELECTRIC CONNECTION.
An excessively high voltage on the conductive part of
the inverter may cause electric shock. When installing
the inverter, make sure that the AC and DC sides of the
Danger
inverter are completely de-energised.
Do not connect the positive or negative poles of the
photovoltaic panel to earth, since this may cause major
Warning
damage to the inverter.
Static electricity can damage the inverter's electronic
components. Take the necessary anti-static measures
Warning
during installation and maintenance.
Do not use terminals of different manufacturers or of
different types, other than those included in the acces-
sory pack. SALICRU shall not be held liable for any form
Attention
of damage caused by the use of unauthorised terminals.
Moisture and dust can damage the inverter; check that
the cable gland is tight enough during installation.
The warranty will be void if the inverter is damaged as
Attention
a result of an improperly installed cable gland.
5.3.1. General wiring diagram.
This diagram shows the structure and composition of the wiring
of the hybrid inverter from the
EQX2-HT
actual project. The installation and wiring must comply with local
series, in relation to the
SALICRU
Publicidad
