Zanussi ZITN844K Manual De Instrucciones página 47

5.3 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the control
bar until you reach the correct heat setting.
5.4 Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook. Cover
the cross / square fully. Induction cooking
zones adapt to the dimension of the bottom
of the cookware automatically. You can cook
with the large cookware on two cooking
zones at the same time.
5.5 Automatic Heat Up
Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the
heat setting.
5.6 PowerBoost
This function makes more power available to
the induction cooking zones. The function
can be activated for the induction cooking
zone only for a limited period of time. After
this time the induction cooking zone
automatically sets back to the highest heat
setting.
Refer to "Technical data"
chapter.
comes on). Immediately
To activate the function for a cooking
zone: touch .
To deactivate the function: change the
heat setting.
5.7 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function or change the
time: touch or
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash, the time
counts down.
To see the remaining time: touch
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To deactivate the function: touch
the cooking zone and then touch
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an
acoustic signal sounds and 00
flashes. The cooking zone
deactivates.
To stop the sound: touch
• Minute Minder
You can use this function when the hob is
activated and the cooking zones do not
operate. The heat setting display shows
To activate the function: touch
touch or of the timer to set the time.
When the time finishes, an acoustic signal
sounds and 00 flashes.
To stop the sound: touch
comes on.
of the timer to set the
to set
to set
. The
.
and then
.
ENGLISH
.
47