Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the oil filler cap/dipstick from the
right crankcase cover.
2. Place an drain pan under the crankcase.
3. Remove the oil drain plug (1), O-ring (2),
spring (3) and oil strainer screen (4).
4. Clean the oil strainer screen.
5. Check that the oil strainer screen, sealing
rubber and drain plug O-ring are in good
condition.
6. Install the O-ring to the oil drain plug.
7. Install the oil strainer screen, spring and
drain plug.
Oil Drain Plug Torque:
15 N·m (1.5 kgf.m, 11 lbf·ft)
8. Fill the crankcase with the recommended
grade oil; approximately:
1.0 l (1.1 US qt, 0.9 Imp qt)
9. Install the oil filler cap/dipstick.
10. Start the engine and let it idle for 2 – 3
minutes.
62
11. Stop the engine and check that the oil
level is at the upper level mark on the oil
filler cap/dipstick with the motorcycle
upright on firm, level ground. Make sure
there are no oil leaks.
(4)
(1) Oil drain plug
(2) O-ring
(1)
(3)
(2)
(3) Spring
(4) Oil strainer screen
Publicidad
