Sony HT-SD35 Manual De Instrucciones página 29

The surround effect cannot be
obtained.
 Depending on the input signal and
the sound mode setting, surround
sound processing may not work
effectively. The surround effect may
be subtle, depending on the program
or disc.
 To play multi channel audio, check
the digital audio output setting on
the device connected to the Sound
Bar. For details, refer to the operating
instructions supplied with the
connected device.
Subwoofer
No sound or only very low-level
sound is heard from the subwoofer.
 Press SW  + on the remote control
to increase the subwoofer volume.
 Make sure that the status indicator on
the subwoofer is lit in green or
orange.
 If the status indicator on the
subwoofer does not light, try the
following.
– Make sure the AC power cord
(mains lead) of the subwoofer is
connected properly.
– Press  (power) of the subwoofer
to turn on the power.
 If the status indicator on the
subwoofer lights in red, try the
following.
– Move the subwoofer to a location
near the Bar Speaker so that the
status indicator on the subwoofer
lights in green or orange.
– Follow the steps in "Performing the
Wireless Connection of the
Subwoofer (SECURE LINK)"
(page 23).
 If the status indicator on the
subwoofer flashes in red, press 
(power) of the subwoofer to turn off
the power and check whether the
ventilation holes of the subwoofer is
blocked or not.
 If the input sources contain very little
bass sound components (i.e., a TV
broadcast), the sound from the
subwoofer may be difficult to hear.
Play the built-in demonstration music
by following the steps below and
check that the sound is output from
the subwoofer.
 Press and hold  (TV) on the Bar
Speaker for 5 seconds.
The built-in demonstration music
is played.
 Press  (TV) again.
The built-in demonstration music
is canceled and the Sound Bar
returns to the previous status.
 Set the night mode to off (page 19).
Mobile Device Connection
BLUETOOTH connection cannot be
completed.
 Make sure that the BLUETOOTH
indicator on the Bar Speaker is lit
(page 8).
 Make sure the BLUETOOTH device to
be connected is turned on and the
BLUETOOTH function is enabled.
 Bring the BLUETOOTH device close to
the Bar Speaker.
 Pair the Sound Bar and the
BLUETOOTH device again. You may
need to cancel the pairing with the
Sound Bar using your BLUETOOTH
device first.
 If the BLUETOOTH function is set to
off, set it to on (page 22).
Pairing cannot be achieved.
 Bring the BLUETOOTH device close to
the Bar Speaker.
 Make sure the Sound Bar is not
receiving interference from a wireless
LAN device, other 2.4 GHz wireless
devices, or a microwave oven. If a
device that generates
29
US