Publicidad
Micro Wire Feed
1. Loosen the fastening knob (A) from the wire feeding
mechanism.
2. Lower the adjusting knob to release the rod cover.
3. Lift the rod cover (G) and fit at least 12" wire (H) into the
wire feeding mechanism guide.
4. Lower the rod cover. Close and tighten the feeding
adjusting rod of the wire feeding mechanism.
• The feeding rod is built with 2 notches for wire
measuring 0.023" and 0.031"
• To select the notch, remove the feeding rod cover turning
half-a turn in a clockwise direction.
• Remove the rod and set it back aligning the selected
notch with the micro wire path.
• Hold the torch to remove the nozzle (I) unscrewing
carefully.
• Then, unscrew the contact nozzle (J) to remove and
release the torch.
• Verify the welder switch is in the OFF position and the
ground clamp is away from the torch tip.
• Connect the welder to the power supply and turn the
welder ON.
• Set the micro wire speed knob into position 5 or 6.
• Untangle the entire torch cable to have it as straight as
possible and press the torch trigger (K). The micro wire (L)
will be fed through the cable and the torch. Allow the
micro wire sticks out approximately 4" through the torch
outlet.
• Turn off and disconnect the welder from the power
supply.
• Slide the contact nozzle over the micro wire and tighten
back in place.
• Slide the nozzle through the micro wire and screw
carefully into the torch outlet.
10
ENGLISH
K
Installation
A
1
H
3
4
J
I
L
G
2
G
Rod Cover
Publicidad
