Publicidad
Installation
Micro Wire Feeding Rhythm
• Connect the welder to the power supply and turn on the
welder switch to verify the micro wire feeding rhythm.
• The micro wire speed towards the torch is controlled from
the control panel using the Micro Wire Speed Control (K).
• Regardless of the selected speed, the micro wire shall be
fed continuously and shall stop immediately upon
releasing the torch trigger. If the micro wire shows
problems to stick out or it does not stop after releasing the
trigger, follow the following adjustments:
M
• Adjust pressure on the micro wire using the tension
knob (L). Consider that excessive pressure hinders the
micro wire feed, thus insufficient pressure cannot push the
micro wire.
• Tighten the spool knob (M). If the knob is too loose the
spool could keep on rotating after releasing the torch
trigger and the micro wire speed would not stop
immediately.
• Keep in mind the torch cable shall be completely
unrolled so that the micro wire can circulate correctly.
• Depending on the job, cut the remaining micro wire so
that it sticks out 0.31" to 0.39" from the contact nozzle.
• Close the cabinet. The welder is ready to work.
L
K
11
ENGLISH
Publicidad
