Publicidad
Technical Data
Power Requirements
General Power Tool Safety Warnings
Safety Warnings for Welders
Parts
Installation
Start Up
Maintenance
Troubleshooting
Authorized Service Centers
Warranty Policy
Use and care recommendations
It is recommended to use a 12 AWG extension cord and connect it to an
INDEPENDENT CHARGING CENTER.
Perform periodic MAINTENANCE to your machine. (Page 16)
2
ENGLISH
When the machine overheats, the thermal protector will activate,
turning the welder off and turning the LED light ALARM on.
Let the welder cool for 15 minutes and turn it back on.
Contents
3
3
To gain the best performance of
the tool, prolong the duty life,
4
make the Warranty valid if
necessary, and to avoid hazards
5
of fatal injuries please read and
understand this Manual before
7
8
Keep this manual for future references.
12
The illustrations in this manual are for reference
16
only. They might be different from the real tool.
17
19
20
CAUTION
using the tool.
Publicidad
