Publicidad
Installation
Micro Wire Spool
CAUTION
• Turn off and disconnect the welder
before opening the cabinet door.
• Push the cabinet locks upwards ( I ) to open and gain
access to the micro wire feeding system.
• Loosen the fastener knob (J) remove the knob, the
spring (O) and the fastener (N) from its axis (K).
• Install the micro wire spool (L) into the axis.
• Set back the fastener (N), then the spring into the axis
(K) and tighten with the knob (J) enough so that the
micro wire spool turns freely.
• Using plyers release the micro wire tip from the spool
notch. Double check the micro wire sticks out from the
lower part of the spool towards the micro wire feeding
mechanism (M).
• Check the micro wire tip is not crooked, bent or it has
alterations or burrs. Cut if necessary in order to have a
straight and flawless tip.
• The micro wire diameter is dependent of the thickness or the material to weld. Small micro wire diameter allows working
with low energy range, deliver less material into the weld and are easy to control, whilst larger micro wire diameter require
more energy to flux the electrode, deliver more material into the weld and are difficult to control.
• The welder can use wires made of different materials and characteristics, like solid wire for gas welding, core wires for
gasless welding or aluminum wire to weld on aluminum. Before installing into the welder, read the manufacturer
specifications of the spool to verify the micro wire is adequate for the job.
CAUTION
• Double check the diameter of torch contact nozzle matches the micro wire diameter installed in the
welder. Otherwise, the micro wire flow can get blocked.
O
N
L
J
I
K
M
ENGLISH
9
Publicidad
